What are the requirements when setting the riser? Below, take a look at these contents!

1. For castings with uneven wall thickness, a riser must be installed at each hot spot.

2, should be set as far as possible on the top of the casting or near the feed part.

3, when the casting has hot spots of different heights to be fed, multiple risers can be set, but the feeding area of each riser must be separated.

4. It is best not to set the riser in the important part of the casting or the place with large force.

5, try to let the inner flow through the riser.

6. Try not to place the riser in the stress concentration of the casting.

7. Riser. It is well set on the surface of the casting that needs to be processed.

The above content is for reference only. Welcome to inquire!